|
ICOM IC-202 |
|
||||
|
General: |
|||||
| Number of semiconductors: | Transistors: | 19 | |||
| FET: | 7 | ||||
| IC: | 7 | ||||
| Diodes: | 36 | ||||
| Frequency coverage: | 144-146 MHz | ||||
| Frequency stability: | Less than 200Hz/h at +25 degres C | ||||
| Antenna impedance: | 50 ohms unbalanced | ||||
| Power supply requirements: | DC13.8V+-15% negative grond 800mA max | ||||
| Current drain: | Transmitting: | A3J | ~540 mA | ||
| A1 | ~750 mA | ||||
| Receiving: | At max audio | ~250 mA | |||
| No signal | ~90 ma | ||||
| Dial light: | ~40 mA | ||||
| Dimensions: | 183(H)x61(W)x162(D) mm | ||||
| Net weight: | 2.0 kg including batteries | ||||
|
Transmitter: |
|||||
| Emission mode: | A3J(USB,LSB) and A1 | ||||
| RF power output: |
A3J 3W PEP |
||||
| A1 2W | |||||
| Carrier supression: | More than 40 db below peak power | ||||
| Unwanted Sideband supression: | More than 40db down at 1000Hz AF input | ||||
| Spurios radiation: | More than 60 db belowpeak ower | ||||
| Microphone:
Dynamic or optinal Electret condenser microphone |
Impedance:600ohms | ||||
| Input level:10 mV typical | |||||
| CW-monitor: | Built-in:Audio level adj. by VOL knob | ||||
|
Receiver: |
|||||
| Receiving system: | Single Conversion Superheterodyne | ||||
| Intermediate Frequency: | 10.7 MHz | ||||
| Receiving mode: | A3J(USB;LSB) and A1 | ||||
| Spurious Response Rejection Ratio: | More than 60 db | ||||
| Sensitivity: | Less 0.5uV for 10 db S+N/N | ||||
| Selectivity: | +- 1.2 kHz at -60 db | ||||
| +- 2.4 kHz at -60db | |||||
| Audio output: | More than 1W | ||||
| Audio output Impedance: | 8 Ohms | ||||
| 144.00
- 144.40 MHz built in(2 crystals).Each crystal gives 200 kHz continuous
coverage:Two spare crystal sockets are provided for additional frequency
ranges between 144.40 - 146.00 MHz |
|||||